Tuesday, December 27, 2011

Pre-Paid Gas and Electricity Customers Penalised For Not Using Direct Debit

!±8± Pre-Paid Gas and Electricity Customers Penalised For Not Using Direct Debit

In the last month it has come to light that energy customers have been severely overcharged for their gas and electricity by not opting in to direct debit schemes. Although the majority of British customers prefer using direct debit, many customers find it easier to budget by only paying for the energy they use rather than working from an estimate.

According to a recent report from the National Housing Federation (NHF), consumers who used alternative pay schemes outside of the usual DD option were being overcharged a massive £464 million over the last three years. In an ideal world, direct debit should present an ideal solution for both consumer and provider, as the gas and electricity suppliers get a constant and reliable stream of revenue direct from customers' bank accounts, and customers get cheaper energy as a result.

The reason gas and electricity is cheaper with DD schemes is that it costs the energy suppliers money to install and maintain pre-paid gas and electricity meters. Companies also like the convenience and security of direct debits which do not rely on customers sending in cash or cheques on a regular basis but go straight to the customer's account. Hence suppliers are willing to offer cheaper gas and electricity to customers who are willing to pay by direct debit.

Energy regulator Ofgem estimates that it costs suppliers an additional £87 a year to maintain pre-paid gas and electricity meters, but some families paid in excess of £500 more for their pre-paid meters, well above the requisite amount. Ofgem have since clamped down on such practices from energy suppliers and customers should not be penalised overly for using alternative payment methods.

However, the point still remains that using direct debit is one of the best ways to secure cheaper energy. Not only is it cheaper, it is also more convenient for customers to not have to remember to pay their bill each month.

Be vigilant though! Suppliers charge direct debit schemes based on averages, which often means customers will be overcharged for energy they haven't used. You can monitor if you are paying too much by checking your meters regularly and contacting your gas and electricity suppliers to check their estimate and your meter reading correlate. You can always get a refund for energy you have been charged for but haven't used. Don't accept credit on your bills; make sure you get your hard-earned cash returned to your bank account.


Pre-Paid Gas and Electricity Customers Penalised For Not Using Direct Debit

5.1 Computer Speakers Best Mens White Pants On Sale 3m Dust Mask Discounted

Wednesday, December 21, 2011

DIY solar accumulated kits, Harbor Freight, Sunforce, Barry's Solar Power Center

This is an older video, one of the first produced. This system has had many revisions since this posting. Please feel free to visit my channel page. On my channel I've cataloged a playlist of over 100 videos demonstrating aspects of DIY solar power setups. pgm98387 channel page playlist; Off the Grid Power Various Videos favorited about off grid power generation. watch 5jwcFsOEiuw youtu.be pgm98387 www.youtube.com www.youtube.com/pgm98387 Battery charging system, 8 Sunforce 15W amorphous panels, 3 Harbor Freight 15W amphorus, 2 55W Siemens. Xantrek Trace C40 Charge controller, Power Bright 1500W pure sine. 11 12V 35Amp Hr. Sealed AGM batteries. This system setup has been upgraded. See latest video here; www.youtube.com youtu.be

Olympus Digital Pen Camera For Sale Braun 51s Decide Now

Thursday, December 15, 2011

DIY Wind Turbine - Ready Low Voltage Disconnect and Charge Controller

I managed to build the charge controller (to check the charging process), the Low Voltage Disconnect (to check the discharge process), and encase them so that it looks good. Wiring everything, so that it doesn't burn when it is ON, was a challenge by itself. By the way, both charge controller and LVD are using the same board made my Glen. The calibration process is a little bit akward for the LVD but once you have everything set, it works just great. The 4 batteries (12V 7Ah) terminals are connected in parallel with the same cable lenght. I read somewhere on the web that it was the best configuration to have a well balanced charge and discharge process as far as batteries voltage are concerned. The next step is to improve my wind turbine. It should be able to keep the batteries charged enough to run the inverter at the same time. After that I would get good batteries and test everything together.

Braun 51s Decide Now Prices Lambswool Mattress Topper

Thursday, December 8, 2011

15 Watt, 12 Volt Solar Panel # 96418 - Harbor Freight Tools

Amorphous crystal solar panel provides superior performance in bright sun and in partial shade. Use this solar panel to power an appliance, light, small motor, or battery, but you must use a voltage regulator (not included) between them to prevent overcharging the battery and consequent damage. This solar panel may also be used to maintain the charge of batteries which are powering other items such as a car radio while the car engine is off. www.harborfreight.com Harbor Freight Tools Quality Tools At Ridiculously Low Prices Sign up to receive our special promotions and coupons pref.harborfreight22.com

Cheaper Singing Machine Karaoke Machine

Sunday, December 4, 2011

Xantrex Charge Controller for DC Charging Sources - 35 Amp, Model# C35

!±8± Xantrex Charge Controller for DC Charging Sources - 35 Amp, Model# C35

Brand : Xantrex | Rate : | Price :
Post Date : Dec 04, 2011 02:00:40 | N/A


Whatever the charging source, this controller is sure to meet your DC controller needs.

More Specification..!!

Shop For Kleenex Free Samples Schwinn Gear Right Now


Twitter Facebook Flickr RSS



Français Deutsch Italiano Português
Español 日本語 한국의 中国简体。







Sponsor Links