I managed to build the charge controller (to check the charging process), the Low Voltage Disconnect (to check the discharge process), and encase them so that it looks good. Wiring everything, so that it doesn't burn when it is ON, was a challenge by itself. By the way, both charge controller and LVD are using the same board made my Glen. The calibration process is a little bit akward for the LVD but once you have everything set, it works just great. The 4 batteries (12V 7Ah) terminals are connected in parallel with the same cable lenght. I read somewhere on the web that it was the best configuration to have a well balanced charge and discharge process as far as batteries voltage are concerned. The next step is to improve my wind turbine. It should be able to keep the batteries charged enough to run the inverter at the same time. After that I would get good batteries and test everything together.
Thursday, December 15, 2011
Thursday, December 8, 2011
15 Watt, 12 Volt Solar Panel # 96418 - Harbor Freight Tools
Amorphous crystal solar panel provides superior performance in bright sun and in partial shade. Use this solar panel to power an appliance, light, small motor, or battery, but you must use a voltage regulator (not included) between them to prevent overcharging the battery and consequent damage. This solar panel may also be used to maintain the charge of batteries which are powering other items such as a car radio while the car engine is off. www.harborfreight.com Harbor Freight Tools Quality Tools At Ridiculously Low Prices Sign up to receive our special promotions and coupons pref.harborfreight22.com
Sunday, December 4, 2011
Xantrex Charge Controller for DC Charging Sources - 35 Amp, Model# C35
!±8± Xantrex Charge Controller for DC Charging Sources - 35 Amp, Model# C35
Whatever the charging source, this controller is sure to meet your DC controller needs.
More Specification..!!
Subscribe to:
Posts (Atom)
|
|
|
|
 |
 |
 |
 |
 |
 |
 |
 |
